I spotted these Wine Cork Placecard Holders ($23.95) at Bright and Bold, which are actually made of resin, and thought they'd make a fabulous and simple DIY for a bridal shower brunch (or any other event). It's kind of a sad fact that these are being mass produced, but we won't get into that. I'm sure most guests would get a kick out of them, especially my girlfriends who are staunch wine fans. If you can handle drinking a few bottles of wine to save up for this DIY, then I think you'll be in the clear, supply-wise. But, you can also have cork stoppers special ordered from an industrial retailer and personalized with "Mrs. X" or "Angie & Brad" etc.
- 1 wine cork per place setting
- Razor blade or X-acto (craft) knife
- Calligraphy pen
- Optional: Hot glue gun and magnet strip
To hear the steps, read more.
- Using the razor blade or craft knife, slice off one side of the cork lengthwise, so it can lay flat on the table. Make sure to use a fresh (sharp) blade, otherwise the cork may crumble.
- Then, with the cork set flat on the table, make a slice down the middle lengthwise, but not all the way through.
- Cut the cardstock to a rectangular shape (or a fun shape) a bit larger than the width of the cork.
- Scribe your guests names using a calligraphy pen.
- If you like, you can hot glue a magnet strip to the bottom of the cork placecard holder. If your table happens to be metal, this will keep it in place and weighted down. If not, you can slip an adhesive magnet under your table cloth to make sure it stays in place.
You can also use this cork placecard holder to display photographs or your bridal shower invites at the center of each table. I love the recycling factor of this DIY, but if you'd like to have your corks personalized, some retailers include Manton, Widget, and Amorim.